AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
So I'll report back with my results in a few days. I've been taking a few days off for another project so I haven't done any more experiments, next one is going to be trying it with another iPod and some different commands. I also used the same method for creating the checksums for all the mode 2 commands that work. So no, I'm not AND'ing it with FF, but that's not necessary unless the first part of the equation would be greater then 100, right? (which it isn't). (signal goes from tx on arduino through 1kohm resistor to rx on ipod and through 2kohm more to ground, pin21 connected to ground with a 500ohm resistor (have tried some different resistors, including 500kohm)) Free download video slank ku tak bisa new version Airlines documentary hd. Here is how i connected it and some code. which means: 4=you exceeded the limit of whatever you were requesting/wrong parameter-count.Įxample, if i send: 0xFF, 0x55, 0x03, 0x04, 0x00, 0x1E, 0xDB i get the response: 0xFF, 0x55, 0x06, 0x04, 0x00, 0x01, 0x04, 0x00, 0x1E, 0xD3.īut I have tried this for quite a few commands, either the information on what parameters to send is wrong, or mode4 commands doesn't work on a 2g nano, or somehow I'm sending it wrong.ĭoes anyone here have any clues to what's wrong? I can get all the mode 2 commands working, but when i try to send mode 4 commands (after switching to mode 4) I get either no response at all (on some commands) or i get an error response (0x04 0x00 0x01 0x04). I'm using the Apple_Accessory_Protocol found on : I have a 2nd generation iPod nano that I'm trying to control with my arduino.
0 Comments
Read More
Leave a Reply. |